Table of Contents
Advertisement
Start-up
Please note
If you are going to be away
Switch on the 5.1 amplifier by setting the mains
for a long period of time or
if the 5.1 amplifier is not
switch on the rear to "On" and set the opera-
being used, switch the mains
tion mode switch ("Off/Auto/On") to "Automat-
switch to "off".
Please note that the volume
ic" mode (middle position). If your PC/DVD player
settings saved on the appliance
is switched off or is not sending output to the 5.1
will be deleted by disconnecting
the mains plug or switching off
amplifier, the 5.1 amplifier will be in standby mode.
the mains switch .
The 5.1 amplifier switches on automatically when
it receives an audio signal. If the signal stops, it
will automatically return to standby mode af-
ter around twenty minutes. When the operation
mode switch is set to "On" , the 5.1 amplifier will
stay on continually (regardless of whether a pro-
gramme is running or not).
Settings on the display
It is also possible to make all equalisation settings
on the subwoofer of the Motiv 5 using the remote
control. The display for the settings is located on
the front of the subwoofer.
The "Mute" button immediately mutes the com-
plete system; if you press it again, the system re-
turns to its previous operating status. When the
system has been muted, the LED under the word
"Mute" on the front of the subwoofer lights up
continuously in red.
The "Channel Selection" button scrolls through
each of the available control areas of the sub-
woofer.
Use the [+] and [-] keys in the "Volume" area to set
each required level. During increases or decreases,
the adjoining LEDs flash red. Once the maximum
or minimum level has been reached, the LED lights
up constantly.
You should ensure that all of the speakers located
around the reception area achieve the same level.
In order to achieve this, it is best to use an equali-
zation measuring device and the sound/signal
generator built into the DVD player/AV receiver.
The level set is automatically saved by the sub-
woofer.
Press the "Reset" button to reset the system to its
original factory settings.
18 Teufel · Motiv 5
Start-up · remote control
Volume
Mute
Reset
–
+
Channel
Select
What is shown in the subwoofer display:
Once the subwoofer has been switched on using
the rear main power switch, the LED under "Pow-
er" lights up green. Even when the system is in
Standby mode, the LED under the word "Power"
lights up green. While the subwoofer is being op-
erated the "Power" LED turns dark. In this case,
the LED under the word "Main" lights up red. The
system is now ready for operation.
Mute = all sounds switched off
Pressing the button once immediately mutes the
complete system; if you press it again, the system
returns to its previous operating status. When
the system has been muted, the LED under the
word "Mute" on the front of the subwoofer lights
up continuously in red
Main
= Total volume
Front
= Volume of the front speakers
Rear
= Volume of the rear speakers
Centre = Volume of the centre speakers
Sub
= Volume of the subwoofer
The red LED marks the control area chosen each
time.
With the exception of Reset, all of the above-
described functions can be called up using the
remote control.
Mute
Channel
Select
+
Volume
–
Teufel
Advertisement
Table of Contents
