Table of Contents
Advertisement
Connecting the satellites
speaker cables (as shown). The speakers and am-
plifier have corresponding [+] and [–] terminals.
The [+] cable of the speaker cable is marked with
a stripe. It is important that you observe the
correct polarity when connecting the speakers:
the plus pole of the speaker to the plus pole of
the amplifier and the minus pole of the speaker
to the minus pole of the amplifier. Connecting
10 Teufel · Motiv 5
Connection: Satellites
To do this, cut the cable
to the required lengths.
Strip the plastic coat-
ing from the ends of the
the cables with the incorrect phases can result
in thin sound, weak bass and reduced stereo
characteristics. For multichannel surround sys-
tems, too, it is important that all speakers are
connected with the correct polarity in order to
ensure an appropriate three-dimensional atmos-
phere and the correct alignment of the sound.
Connect the speakers to the correspondingly
marked clamp connections on the rear of the
subwoofer; i.e. the front left speaker to FL and
the rear left speaker to RL and so on.
FRoNt SPeAkeR
+
–
leFt
FRoNt SPeAkeR
+
–
RigHt
ReAR SPeAkeR
+
–
leFt
ReAR SPeAkeR
+
–
RigHt
CeNtRe
+
–
CoNNeCtoR PANel,
SuBwooFeR
ReAR SiDe
FRoNt
+
–
leFt
FRoNt
+
–
RigHt
ReAR
+
–
leFt
ReAR
+
–
RigHt
CeNtRe
+
–
SPeAkeR leVel outPut
Advertisement
Table of Contents
