Table of Contents
Advertisement
SpeedClean Comfort 75 / SpeedClean Comfort 50 / SpeedClean Eco 30 2012 V01
Make sure all hose connections are tight, and that no hose is bent or has several twists.
5.3 Connecting and installing pump filter model 30 Eco
a) The filter pump is screwed onto the top of filtration equipment. Screw the two screws (1) at the top of the lid.
b) Place the pump on the cover and fasten on both sides with screws on top of the lid.
c) After the front screw pump to the cover parts pointing downward vertical connection through the nut (2) is
above the set. Verify that the pump is properly attached to the cover and eventually tighten the screws.
Filtration equipment towards the pool (pressure side)
from the pool filter pump (suction side)
6 Modes filter
Comfort SpeedClean 75/50
Regulation
Function: Inhaling, normal operation of the filter. This is the most
Function: Inhaling, normal operation of the filter. This is the most
common regulation. In this position, the water drawn in enters
the pool above the filter vessel, which continue through the
sandbed. During the passage of water through the sand screen
sandbed. During the passage of water through the sand screen
Filter
to the bottom, all the impurities are retained and then water
returns to the pool.
position 1
Function: It is used to clean the filter back to litter (sand) after
Function: It is used to clean the filter back to litter (sand) after
backwashing. This process should always be
backwashing. This process should always be
subsequent
commissioning. In this position, the water is conducted to the
commissioning. In this position, the water is conducted to the
rinsing
upper area of t he filter container, whereby the valve is cleaned,
while water is drained through pipe dirty water.
position 2
Connection options
Total water flow, or function
immediately after a backwash a sand filled or
8
Spiral hose reinforcement Ø
32/38 mm
Spiral hose reinforcement Ø
32/38 mm
Valve position
1
2
Hide quick links:
Advertisement
Table of Contents
