Warranty; Damage Resulting 2.4; Technical Data; Installation Instructions - Steinbach Speedclean Comfort 75 Assembly Instructions Manual

SpeedClean Comfort 75 / SpeedClean Comfort 50 / SpeedClean Eco 30 2012 V01

2.3 Warranty

Warranty regarding operational safety and reliability will only be accepted by the manufacturer under the following conditions:
• The filtration equipment must be installed and operated in accordance with the installation instructions and instructions for use.
• Repairs should be made only with original parts (wear parts are not subject to warranty).
Wear parts that are not subject to warranty are:
• all O-rings
•
Pressure gauge
• full frontal Reten

Damage resulting 2.4

We accept no liability for product damage caused by failure to comply with the instructions of these instructions.
3 Technical information
Flow rate (Q)
Operating pressure
filter area
rated voltage
Wattage
Protection class
Max. room temperature
Amount of sand, size
0.4-0.8 mm grain
Before installing the filtration equipment it is imprescinbible verify that the water level in the pool is higher than the water level of the
filter pump. Therefore, if the pump to a lower pool used, it must prepare a surface large enough for mounting the filter pump, to filter pump. Therefore, if the pump to a lower pool used, it must prepare a surface large enough for mounting the filter pump, to
ensure that the water level in the pool is highest. The filter pump is not self-priming. ensure that the water level in the pool is highest. The filter pump is not self-priming.

4 Installation instructions

4.1 Unpacking filter system
Packaging carefully remove the product and all its components. Before starting the installation, check that all parts are listed on the waybill, and Packaging carefully remove the product and all its components. Before starting the installation, check that all parts are listed on the waybill, and
that nothing is missing. NOTE: Some parts are in the filter vessel. To remove these parts, remove the cover of the filter housing. (On the last that nothing is missing. NOTE: Some parts are in the filter vessel. To remove these parts, remove the cover of the filter housing. (On the last that nothing is missing. NOTE: Some parts are in the filter vessel. To remove these parts, remove the cover of the filter housing. (On the last
page of these instructions there is an exploded view complete filtration equipment).
Comfort 50
6,6 m³ / h - 0.4 bar
1.5 bar
0.13 m²
230V 50Hz AC 1N ~ 230V 50Hz AC 1N ~
450
IP X5
35 ° C
15 kg
ECO 30 - WARNING
5
Comfort 75
8 m³ / h - 0.4 bar 3.8 m³ / h - 0.4 bar
1.5 bar
0.13 m²
230V 50Hz AC 1N ~
550
IP X5
35 ° C
25 kg
Eco 30
1.5 bar
0.13 m²
200
IP X5
35 ° C
12 kg