Table of Contents
Advertisement
SpeedClean Comfort 75 / SpeedClean Comfort 50 / SpeedClean Eco 30 2012 V01
The valve lever should never be used to lift or carry the filter.
6.1
Startup
Once the filtration equipment is fully assembled, you have sand in the sand chamber and all hoses are connected, you can start commissioning. In
Once the filtration equipment is fully assembled, you have sand in the sand chamber and all hoses are connected, you can start commissioning. In
all cases recommend you first, a cleaning of the sand charged is made. Cleaning the sand before filtering the pool water removes most dirt and
all cases recommend you first, a cleaning of the sand charged is made. Cleaning the sand before filtering the pool water removes most dirt and
small particles possibly contained in the sand. If you immediately start with filtering, these particles will end up in your pool. To clean the sand,
follow the below mentioned instructions.
Connect the power supply only when it is explicitly mentioned.
1) Make sure the power cord (mains lead) pump is unplugged.
2) Place the valve lever in the "closed" position.
3) If your pool is not full yet, now fill it with water. Pay attention to the water level of the pool is at least 2.5 to 5 cm above the nozzle
hole filling (skimmer).
4) Open the valve blocking the filling nozzle (skimmer) of the pool. If the filling nozzle (skimmer) is closed with a cap, remove it now.
5) As the location of the filter is lower than the water level of the pool, the computer automatically fills with water.
6) Fill the filter vessel with water.
7) Verique that the filtration equipment and the connection hoses for leaks and eventually eliminate them. Due to manufacturing
tolerances techniques, it may happen that in some places leaking Teflon tape needed to overwhelm the connections before
placing the hose, eliminating leakage.
8) Run the backwash process described on the next page.
6.2 Resaca
•
Disconnect the pump by unplugging the network cable.
•
Connect the backwash hose (not included in delivery) with the backwash outlet in the filter cover.
•
Place valve 7-way or 3-way backwash position.
•
Connect the pump to the power supply (the mains cable plug) again.
•
Perform the backwash long enough so that the water leaving the pipe is clean.
•
Disconnect the pump by unplugging the network cable.
•
Place valve 7-way position in the rear flush. With the 3-way valve that is not possible.
•
Connect the pump to the power supply again.
•
Let the filter run 60 seconds in this operating mode, to remove all residues in the pump or valve.
•
Disconnect the pump by unplugging the network cable.
•
Place valve 7-way or 3-way filtering position.
•
Connect the pump to the power supply again.
•
His team is now running filtration.
ATTENTION
ATTENTION
eleven
Hide quick links:
Advertisement
Table of Contents
