Download Print this page

SKIL MASTERS 9371 Operation Instruction Manual

Hide thumbs Also See for 9371:

Advertisement

Quick Links

SKIL Europe BV - Konijnenberg 60
4825 BD Breda - The Netherlands
www.skilmasters.com
08/09
ANGLE GRINDER
9371 (F0159371..)
2610399985

Advertisement

loading
Need help?

Need help?

Do you have a question about the 9371 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SKIL MASTERS 9371

  • Page 1 ANGLE GRINDER 9371 (F0159371..) www.skilmasters.com SKIL Europe BV - Konijnenberg 60 08/09 2610399985 4825 BD Breda - The Netherlands...
  • Page 2 9371 EPTA 01/2003 Watt 2.1 kg Ø 115 mm 12000/min 110 V 110 V Ø 22 mm RUBBER...
  • Page 3 NOT INCLUDED...
  • Page 5 ACCESSORIES 115 mm SKIL Nr. 2610Z00256...
  • Page 6 Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. Angle grinder 9371 d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. INTRODUCTION Keep cord away from heat, oil, sharp edges or moving parts.
  • Page 7: Kickback And Related Warnings

    d) Store idle power tools out of the reach of children f) Do not use a damaged accessory. Before each use and do not allow persons unfamiliar with the power inspect the accessory such as abrasive wheels for tool or these instructions to operate the power tool. chips and cracks, backing pads for cracks, tear or Power tools are dangerous in the hands of untrained excess wear, wire brushes for loose or cracked...
  • Page 8 • For example, if an abrasive wheel is snagged or pinched 4) ADDITIONAL SAFETY WARNINGS SPECIFIC FOR by the workpiece, the edge of the wheel that is entering CUTTING OFF OPERATIONS into the pinch point can dig into the surface of the a) Do not “jam”...
  • Page 9 GENERAL DURING USE • Only use this tool for dry grinding/cutting • Inrush currents cause short-time voltage drops; under • Only use the fl anges which are supplied with this tool unfavourable power supply conditions, other equipment • This tool should not be used by people under the age of may be affected (if the system impedance of the power 16 years supply is lower than 0,104 + j0,065 Ohm, disturbances...
  • Page 10: Maintenance & Service

    • On/off locking switch H 8 ENVIRONMENT - switch on tool 8a • Do not dispose of electric tools, accessories and ! be aware of the sudden impact when the tool is packaging together with household waste material switched on (only for EU countries) ! before the accessory reaches the workpiece, - in observance of European Directive 2002/96/EC on...
  • Page 11 ✎...