Westfalia 84 76 36 Instruction Manual page 11

Operation
Melting
Remove the protective cap from the melting point. To switch on the
wax melter push forward the entire switch assembly and then push
the button on the slider. The tip will be heated while the button is
pressed and held and the red LED lights up.
Always melt small amounts of wax from the sticks at a time.
Filling
Fill the damaged area in small steps until there is a slight excess of
wax. Always work from lighter to darker colours.
For vertical surfaces it is advisable to mix the colour beforehand and
apply it with the scraper.
Finishing
Allow the wax to solidify for 5 -7 seconds and carefully remove the
excess with the flattening tool and the scraper. If necessary apply
light pressure.
Use darker wax to imitate the grain of the wood. After that, again
remove the excess with the flattening tool.
Finally, remove way residue with the abrasive sponge and adjust
the shine to the rest of the work piece.
If necessary, repeat the procedure.
Cleaning, Maintenance and Service
The flattening tool can be cleaned with the serrated edge of the
scraper. With the serrated edge, residual wax can be removed from
the grooves.
Keep the wax melter dry and clean for safe and easy work.
Do not use liquids, abrasives or solvents for cleaning the wax
melter. Either remove hot wax with the scraper and a paper towel or
allow the wax to solidify and then carefully remove the cold wax.
Store the melter indoors in a place protected from dust, dirt and
extreme temperatures out of the range of children.
11