Cleaning And Maintenance - Wahl MINI PRO Manual

OUTLINING
No attachments are needed. Comb hair into a desired
style. Starting between the ear and the sideburns,
hold the product with the corner edge of blade against
hairline. Slowly follow the desired outline of the
hair over, around and behind the ears. For defining
sideburns and the back of the neck, hold the product
upside down, against the skin at the desired length
and move down.
Comb hair and check that sides are even. Check for
uneven spots throughout the haircut.
SHORT CUTS
Starting with the longest guide comb, cut from the back
of the neck to the crown. Hold the guide comb flat
against the head and slowly move the product through
the hair.
Use the same procedure from the lower side to the
6
Where the world goes to look good.
W a h l s a l o n
upper side of the head. Then cut the hair against the
direction in which it grows, from the front to the crown
and even up the cut with the sides.
To give a flattop look, the hair on top of the head must
be cut over the top of a flat comb, rather than using the
guide comb.
Use closer cutting guide combs to taper the hair down
the neckline, as desired. Comb hair and check for
uneven spots. Outline sideburns and necklines as
previously described.

CLEANING AND MAINTENANCE

OIL
The blades of your new product should be oiled before
and after every use. Place a few drops of Wahl Clipper
oil on the teeth of the blades. Use only Wahl Clipper
Oil included in the pack. Do not use hair oil, grease or
any oil mixed with kerosene or any solvent.
i n n o v a t i o n s