Cleaning And Maintenance - Wahl Blitz Instructions Manual

Blitz Trimmer
trimmer up and outward through the hair, cutting only
a small amount at a time.
Repeat around sides and back of head.
If you desire shorter hair, either change to a shorter
guide comb or apply more pressure and less lift away
from head with the present attachment.
This entire procedure requires practice, and it is
always better to leave too much hair the first few
haircuts.

CLEANING AND MAINTENANCE

SHAVER HEAD CARE
For maximum performance, we recommend you
clean your shaver after every few shaves.
To clean, turn shaver "OFF" and remove the foil head
by pushing the shaver head release buttons on the
sides of the shaver and lifting the foil head upward.
Lightly tap the open side of the foil head on a hard
surface to remove the majority of loose stubble
particles. Be careful not to tap foil.
TO REMOVE CUTTER BAR
Turn shaver off. Remove the foil head and, holding
the shaver in one hand, gently pull up on cutter bar.
Be sure your thumb and first finger are positioned at
each end of the cutter bar. Use the cleaning brush
provided to remove whiskers between the cutting
blades. NOTE: If you do not hold the cutter bar as
shown, brushing the blades could result in damage to
the assembly.
When the foil head and cutter bars are removed
from the shaver, an alternate cleaning method is to rinse them under running
13