Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Renfert MTplus
Summary of Contents for Renfert MTplus
- Page 1 MTplus No.1803-x000 /-x500 Ideas for dental technology...
- Page 4 100V 120V NO !
- Page 6 12 h...
-
Page 7: Application Area
This 2. Application Area appliance may be connected / used only by authorized and The MTplus is a model trimmer designed qualified persons after checking for use in dental technology operations to its conformity with respect to the grind plaster models. -
Page 8: Liability Exclusion
7. Plug the power cord into the wall outlet (Fig. 7). 8. Switch the unit on (Fig. 8). 9. Adjust the water flowrate (Fig. 9). Attention: the water inlet is closed on delivery. The MTplus is now ready for use as a wet trimmer. - 2 -... - Page 9 • Switch on the MTplus (Fig. 8), switch with diamond-coated discs. Over- the extractor on automatic use. heating will damage the disc. The MTplus is now ready for use as a dry • The water supply shutoff tap trimmer. should be turned off during longer work interruptions or overnight.
-
Page 10: Cleaning & Maintenance
• Dry trimming is not allowed when the MTplus. MTplus is equipped for wet trimming. • Wet trimming is not allowed when the 1. Disconnect the unit from the power MTplus is equipped for dry trimming. - Page 11 8. If necessary, clean the flange 5.3 Spray Tube Replacement / (refer to Section 5.2). Cleaning (Wet Trimmer) 9. Place a new disc on the lock pin 1. Remove the rinse tube (refer to Sec- (Fig. 30). tion 5.1, steps 1-5). 10.
-
Page 12: Spare Parts
2,830 rpm (230 V / 230-240 V, 50 Hz) Provided the unit is properly used, Renfert 3,420 rpm (120 V, 60 Hz) warrants all parts of the MTplus for a 2,870 / 3450 rpm (100 V, 50/60 Hz) period of 3 years. In case of any claims Connection piece diameters for for warranty original dealers‘... -
Page 13: Delivery Versions
10. Delivery Versions 12. Accessories No. 1803-0000 MTplus, 230 V / 50 Hz No.2011-0000 GO-2011, plaster solvent No. 1803-0500 MTplus, 230 V / 50Hz, Trimming discs - for wet trimming only: incl. Marathon trimmer No. 1803-1000 Basic kit: disc 5 Klettfix silicon carbide No. -
Page 14: Troubleshooting Guide
13. Troubleshooting Guide Fault Possible cause Corrective action Device fails to • Power supply not • Check the mains power supply. start. established. • Mains fuse faulty. • Check the mains fuse. • Front cover not pro- • Close the front cover (Fig. 11). perly closed. - Page 15 Wet Trimming: Fault Possible cause Corrective action Disc buildup. • Water volume incor- • Increase the water volume at the rectly adjusted at the trimmer (Fig. 9). device. • Water supply not fully • Open the water supply (Fig. 6). open.
- Page 16 Corrective action Disc buildup. • Models are too wet. • Clean the disc with a brush under running water or with plaster solvent (Renfert GO-2011 Art. No. 2011-0000). Excessive dust • Extraction not switched on. • Switch the extraction on.