Input Selection And Av Connections - Input And Output Sockets For Connected Equipment; Hdmi Audio - Toshiba 27WL56 Series, 32WL56 Series, 37WL56 Series Owner's Manual

Input selection and AV connections
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket. Alternatively press the external source
selection button until the picture from connected
B
equipment is shown.
An S in the display e.g.
B
input is set for an S-Video signal.
Input selection
Use the Input Selection if the television does not switch
over automatically.
Press to select
B B
1
HDMI, PC or YUV.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press
2
one of the numbered buttons.
INPUT signal selection
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press Q until
1
AV connection is highlighted, then press OK.
With S or R select either AV or S-VIDEO as the
required input for EXT2.
If the colour is missing try the alternative setting.
AV Connection
PC/YUV audio

HDMI audio

EXT2 input
MENU Back EXIT
3S (EXT 3S), indicates the
1, 2, 3 (EXT1-3),
B B
again or
B
No
Auto.
S-VIDEO
Watch TV
In order to receive sound from a connected PC or
component video source, plug the audio cable into the
back of the television (as shown in the 'Connecting a
computer or component video source' section), then
In the AV connection menu highlight PC/YUV
1
audio. With S or R select either Yes or No.
PC/YUV audio
HDMI audio
EXT2 input
Back
MENU
NOTE: Selecting PC/YUV audio will force HDMI
into digital audio.
If the connected HDMI source does not support digital
audio, plug the audio cable into the back of the television
(as shown in the 'Connecting a computer or component
video source' section), then use the HDMI audio settings.
In the AV connection menu press Q to highlight
1
HDMI audio. Using S or R select Auto. or
Analogue.
PC/YUV audio
HDMI audio
EXT2 input
Back
MENU
If the sound is missing select the alternative
setting.
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
19
PC/YUV audio
select PC/YUV audio.
AV Connection
Digital
S-VIDEO
Watch TV
EXIT
HDMI audio
AV Connection
S-VIDEO
Watch TV
EXIT
Yes
No
Auto.