Table of Contents
Advertisement
CONTROLS AND FEATURES
Input selection and AV
connections
See page 8 for a clear view of the back connection
recommendations.
Most media recorders and decoders send a signal through the
SCART lead to switch the television to the correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
This button must be used to view equipment connected using
the COMPONENT VIDEO INPUT (EXT3).
o
An S in the display e.g.
2S (EXT 2S), indicates the input is set
for an S-Video signal.
Input Selection
Use the Input Selection window if the television does not switch
over automatically.
o
At any time by pressing
on the remote control or TV, a list
will appear on screen showing all inputs and external
equipment.
HDMI™ displays equipment connected to Input HDMI on the
back or side of the television.
PC displays a computer connected to Input RGB/PC on the
back of the television.
INPUT Signal Selection
This specifies the type of signal going into SCART 2 (EXT 2) on
the back of the television. Please refer to the manufacturer's
instructions for the connected equipment.
a
In the SET UP menu press
highlighted, then press
b
o
b
Press
select either AV or S-VIDEO as the required input for
EXT2.
If video colour is absent, try the alternative setting.
In order to receive sound from a connected PC, plug the audio
cable into the back of the television (as shown in 'Connecting a
computer' section), then use the PC/HDMI1 audio setting.
a
In the SET UP menu press
highlighted, then press
b
Highlight PC/HDMI1 audio then press
select PC.
NOTE: Selecting PC will force HDMI1 audio to Digital.
30
b
until AV connection is
Q
.
to select EXT2 input then press
PC Audio
b
until AV connection is
Q
.
C
c
or
to
C
c
or
to
Advertisement
Table of Contents
