Network Setting Checklists - Toshiba Multifunctional Digital System GA-1190 Network Administration Manual

Network Setting Checklists

When a computer cannot print data to this equipment through a network, check if the settings
are correctly made according to Chapter 1 "EASY SETUP FLOW" by referring to the checklists
shown below. The checklist covers major printing setting items explained in Chapter 1 "EASY
SETUP FLOW".
Raw TCP or LPR printing in a Windows operating system environment:
No.
1 Are the IP Address proper-
ties correctly set?
2 Is the Raw TCP Printing
correctly set?
3 Is the LPR/LPD Printing cor-
rectly set?
4 Were the proper printer driv-
ers installed?
5 Is the Raw TCP or LPR port
configured with correct IP
address?
6 Can you print to this equip-
ment?
IPP printing in a Windows operating system environment:
No.
1 Are the IP Address proper-
ties correctly set?
2 Is the HTTP Server on this
equipment enabled?
3 Is the IPP Printing correctly
set?
4 Were the proper printer driv-
ers installed?
5 Is the IPP port configured
with correct URL?
6 Can you print to this equip-
ment?
Check Item Yes
Next Step
Next Step
Next Step
Next Step
Next Step
End
Check Item Yes
Next Step
Next Step
Next Step
Next Step
Next Step
End
No Countermeasure
Set up the IP address correctly.
Set up the Raw TCP print service
correctly.
Set up the LPD print service cor-
rectly.
See the Printing Guide to install
proper printer drivers.
See the Printing Guide to config-
ure the proper port.
Refer to the following section to
troubleshoot the condition.
P.55 "Cannot print data to this
equipment"
No Countermeasure
Set up the IP address correctly.
Enable the HTTP server in the
HTTP Network Service.
Set up the IPP print service cor-
rectly.
See the Printing Guide to install
proper printer drivers.
See the Printing Guide to config-
ure proper port.
Refer to the following section to
troubleshoot the condition.
P.55 "Cannot print data to this
equipment"

Network Setting Checklists

45