Download Print this page

Module 1 - Tannoy QFLEX 64 Mounting And Installation Manual

Table of Contents

3.1.1 Module 1

Module 1 (complete with the joining plate fitted) attaches to the bottom two

mounting blocks as shown below. (Fig .1 and Fig .2)

Align the dowels with the holes on the mounting block and lower into place. (Fig .1)

Now add the plain washer above the lock nut and run up until it makes contact but still allows column

to move freely. (Fig .2)

Attached module should appear as (Fig. 3)

Fig .1

Fig .2

Mounting Block 7 Detail

Plain washer

Lock nut (max torque 22 Nm)

QFLEX 64 Mounting and Installation Guide rev 1.1.0

3. Fixing the QFlex 64 to the bracket

Mounting

Block 7

Mounting

Block 6

Mounting

Block 5

Mounting

Block 4

Mounting

Block 3

Mounting

Block 2

Mounting

Fig .3

Block 1

Table of Contents