Advertisement
INSTALLATION
How To Install The Faucet
The product you have selected has quick, drop-in installation feature.
Flush the water supply pipes thoroughly to remove debris.
Slip the washer(1) over the flexible hoses and mounting stud, and into
the groove on the body assembly.
If needed to take off the hoses to repair, reinstall and tighten them by
hand.
①Insert flexible hoses and tighten it. Insert the washer(2) and the
connecting nut(3) into the hole in deck. Position the connecting nut
between flexible hoses.
②Center the washer and faucet over hole. Tighten with supplied
wrench. Check that the nut is centered and flexible hoses hang freely.
Attach the hoses to water supplies. When facing front of faucet, the
left hose is hot water, the right hose is cold water.
For 9076A-4ND
Insert the plug(4) into hole on the back of the faucet if not install
pop-up drain.
How To Install The Drain(Not For 9076A-4ND /9076-ND)
Remove flange(6) from drain body(8). Slide the washer(7) onto the
underside of the drain flange. Apply thread tape to tailpiece(9) and
install it to drain body(8). Insert drain body from underside of bidet
with drain lever hole (13) facing to the back of the bidet. Thread
flange(6) onto drain body by hand. Tighten the locknut(12) by hand
from the underside .
Place stopper(11) into drain body aligning the flat side of stopper
hole(10) with the drain lever hole.
NOTE: If needed apply a ring of plumbers putty around the underside
of the drain flange(6), instead of using washer(7).
Place the rubber washer(14) into the drain lever hole. Put another
plastic washer(15) and retaining nut(16) into the long end of the ball
lever rod(17).
Insert the ball lever assembly(18) into the drain lever hole and through
the stopper hole, and tighten the retaining nut.
Be sure that the ball lever points to the back of the bidet. Tighten the
locknut on the drain body. Remove any excess putty.
NOTE: Do not reposition the drain after the locknut is tightened, or
you may break the putty seal.
836770A-C
1
2
3
4
11
10
7
6
6
8
12
9
13
17
16
15
14
18
12
2
Assemble thumb screw(21) to link(22), and link onto ball lever rod
with 'V' clip(23). Slide lift rod(20) through hole in faucet and into the
hole in link. Position the lift rod so bottom of the lift rod knob(19) rests
against the faucet body.
Push the ball lever down into the open position.
Tighten thumb screw.
Connect the tailpiece(24) to the trap(25). The tailpiece should extend
25mm to 50mm into the trap.
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight.
Ensure that the lever handle is in the down position.
Open the drain.
Turn on the main water supply, and check for leaks. Repair as
needed.
Remove the aerator(26). Run hot and cold water through the faucet
for about one minute to remove any debris. Check for leaks. Remove
any debris from the aerator assembly. Shut the faucet off, and
reinstall the aerator assembly.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
836770A-C
19
20
21
22
18
23
24
25
26
3
Advertisement
