LG VR6140LVM Owner's Manual page 36

BEFORE YOU CALL FOR SERVICE
Confirm before reporting the failure of HOM-BOT 2.0.
Problem
The HOM-BOT 2.0 will not
activate.
Movements or travel path are
abnormal.
Suction power becomes weak.
Noise becomes louder.
The HOM-BOT 2.0 cannot
be activated with the remote
control.
The brush does not rotate.
The HOM-BOT 2.0 will not
charge.
Automatically starts
searching for home station.
Automatically turns
the power off.
The power supply cannot be
turned on.
34
Solutions (Reference page)
s Confirm that the power switch is turned on. (Page 14)
s Confirm that the battery has been charged. (Page 17)
s Carefully wipe the sensor with a smooth cloth. (Page 28)
s If the ultra microfiber mop is attached, confirm that it is mounted
properly. (Page 21)
s Turn on the power switch off and on.
s Check whether there is foreign material blocking the suction port.
(Page 27)
s Empty the dust bin. (Page 25)
s Clean the dust bin filter. (Page 26)
s Confirm that the dust bin has been mounted properly.
s Confirm that the dust bin filter has been mounted properly.
(Page 26)
s Check whether foreign material is caught in the brush. (Page 27)
s Please check if there is any tape, gum or other kind of foreign
materials are on the wheel.
s Replace the remote control batteries. (Page 11)
s Confirm that the control is within the coverage area of the main unit,
which is less than 3 m or 9.84 ft. (Page 11)
s Check whether the main power switch on the bottom is turned on.
(Page 14)
s Clean the brush. (Page 27)
s Confirm that the brush has been mounted properly. (Page 27)
s Remove objects around the home station. (Page 13)
s Confirm that the power supply is connected to the home station.
(Page 13)
s Wipe the charging terminal with a dry cloth.
s Press the reset button on the back of the home station for
3 seconds while the HOM-BOT 2.0 is attached to the home station.
(Page 14)
HOM-BOT 2.0 will automatically return to the home station to recharge
when it's left uncharged or without cleaning order for more than 10
minutes.
Check that the power switch is turned on. (Page 14)