Table of Contents
Advertisement
00873A-SD-6980SY-2
8/22/05 4:40 PM
Reference
Troubleshooting
Before requesting service (troubleshooting), please check the following.
Problem
No operations can be
performed with the
remote control.
Disc does not play.
5.1 channel sound is
not being reproduced.
The
icon appears
on screen.
Disc Menu doesn't appear.
Play mode differs from
the Setup Menu
selection.
The screen ratio
cannot be changed.
No audio.
The screen is blocked.
Forgot password.
If you experience other
problems.
The picture is noisy or
distorted.
No picture or
abnormal colour
(pinkish, greenish etc,)
Page 72
• Check the batteries in the remote control.
They may need replacing.
• Operate the remote control at a distance of not more than 20 feet.
• Remove batteries and hold down one or more buttons for several minutes to
drain the microprocessor inside the remote control to reset it. Re-install
batteries and try to operate the remote control again.
• Ensure that the disc is installed with the label side facing up.
• Check the region number of the DVD.
• 5.1 channel sound is reproduced only when the following conditions are met. :
1) The DVD player is connected with the proper Amplifier.
2) The disc is recorded with 5.1 channel sound.
• Check whether the disc being played has the "5.1 ch" marked on the outside.
• Check if your audio system is connected and worked properly.
• In a SETUP Menu, is the Audio Output set to Bitstream?
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
2. The DVD's software doesn't support the feature (e.g., angles).
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of range.
• Check if the disc has a Menu.
• Some of the functions selected in the Setup Menu may not work properly if the
disc is not encoded with the corresponding function.
• The Screen Ratio is fixed on your DVDs.
• Make sure you have selected the correct Digital Output in the Audio Options
Menu.
• Press the
button for more than 5 seconds under no disc inside.
All settings will revert to the factory settings.
• Press and hold the
button for more than 5 seconds under no disc inside.
All settings including the password will revert to the factory settings.
Don't use this unless absolutely necessary.
• Go to the contents and find the section of the instruction book that contains
the explanations regarding the current problem, and follow the procedure once
again.
• If the problem still cannot be solved, please contact your nearest authorized
service center.
• Make sure that the disc is not dirty or scratched.
• Clean the disc.
• Make sure the correct video output setting is selected in this unit.
• Make sure the video outputs are connected correctly.
ENG-72
Action
Page
P6
P10, 23
P22
P60~61
–
–
P55~69
P64~65
P60~63
P23, 66
P67~69
–
P9
P65
P14~18
Advertisement
Table of Contents
