Heatilator ECOCHOICE ECO-ADV-PS35 Owner's Manual page 18

HEATILATOR ECO CHOICE
8. Soot and Fly Ash: Formation & Need for Removal in
Exhaust Venting System.
• Frequency: Yearly or more frequently depending on
ash build-up.
• By: Qualified Service Technician/Homeowner
Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
The products of combustion will contain small particles
of fly ash. The fly ash will collect in the exhaust venting
system and restrict the flow of the flue gases.
At start-up if there is incomplete combustion, or if there is
a shutdown or incorrect operation of the appliance it will
lead to some soot formation. This will collect in the exhaust
venting system.
The venting (chimney) system may need to be cleaned at
least once a year or more often depending upon the quality
of your fuel or if there are any horizontal pipe sections. Ash
will build up more quickly in the horizontal sections and
elbows.
9. Door Handle Inspection
• Frequency: Monthly or prior to heating season
• By: Homeowner
The gasket between the glass and firebox should be
inspected periodically to make sure there is a good seal.
Check door handle for smooth cam operation.
Door Cross
Latch Cam
Section
Locknut
Spacing
Washers
Figure 18.1
18
Spring
Handle
Door Handle
Shaft
Square Key
7058-206I
10. Cleaning the Glass
• Frequency: When clear view of the firepot becomes
obscure
• By: Homeowner
a. Appliance must be completely cool before cleaning
glass.
b. Vacuum fly ash from glass and door rope.
c. Use a damp paper towel or any non-abrasive glass
cleaner. Wipe off with dry towel.
CAUTION
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or
slamming glass.
• Do NOT clean glass when hot.
• Do NOT use abrasive cleaners.
• Refer to maintenance instructions.
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch
glass.
• Do NOT operate appliance with
glass assembly removed.
11. Cleaning Exhaust Blower - Requires No
Lubrication
• Frequency: Yearly or more frequently depending on
ash build-up
• By: Homeowner or Qualified Service Technician
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Follow the directions for cleaning the exhaust path
found on page 15.
c. If unable to thoroughly clean the blower through
this access, then follow the directions on page 22
for direct access to the exhaust blower.
d. Vacuum the blower's impellers. Use care not to
bend or damage the blower fins.
NOTE: Hearth & Home Technologies recommends to
use a heavy duty vacuum cleaners specifically
designed for solid fuel appliance cleaning.
August 21, 2018