Loewe Reference Sound Standspeaker Slim Operating Instructions Manual page 5

Setting up
Installing the Reference Sound
Standspeaker Slim system
Basic information
CAUTION: THE ALUMINIUM SURFACE OF THE REFERENCE SOUND STANDSPEA-
KER SLIM IS VERY SENSITIVE TO SCRATCHING AND IMPACT. AVOID ALL
CONTACT WITH SHARP OBJECTS. DO NOT PLACE VASES, CANDLES OR OTHER
OBJECTS ON TOP OF THE UNIT.
CAUTION: DO NOT CONNECT THE REFERENCE SOUND STANDSPEAKER SLIM TO
AN AMPLIFIER OUTPUT, WHICH EMITS FREQUENCIES ≤ 150 HZ, IN ORDER TO
AVOID DAMAGING THE LOUDSPEAKER.
• Place the speaker on a firm, level base.
• Please note, that the speakers consist of a right and left unit. A mark is on
the product label at the base of each unit.
• Do not place the speakers near to strong sources of heat or in direct sunlight.
• Pull out the power adapter during thunderstorms. Surge voltages caused by
lightning strikes can damage the unit.
• Also remove the power adapter in long periods of absence.
• The power adapter set must be easily accessible so that the unit can be
disconnected from the power supply at all times.
• Lay the speaker and power cables in such a way that they cannot be dama-
ged. The power cable may not be kinked or laid over sharp edges, not stood
on and not exposed to chemicals; the latter also applies to the system as a
whole. A power cable with damaged insulation can lead to electric shocks
and is a fire risk and must therefore be changed by qualified service personnel
before operation of the set continues.
Optimum arrangement
Please note, that due to the the operating principle of the Reference Sound
Standspeaker Slim, the sound is emitted on the front and rear side.
It is useful if the distance from the walls (to the rear as well as left and right) is
about equal, so that the sound distribution into the room may be optimal.
In addition, the sound emission is directional.
It is therefore recommended to arrange the speaker in a way, that they face into
your preferred listening position (page 6).
5 -