Wolf CSO24 Service Manual page 26

CSO24 and CSO30 (SWS #13508346)
Light Bulb Removal
To remove a light bulb, first remove the left side rack
guide, then (See Figure 4-7):
1. Extract screws securing oven light frame to left side
wall.
2. Pull frame and light glass cover from side wall.
NOTE: The oven light seal does not need to be
removed.
3. Extract bulb from light socket by pulling it toward
rear of cavity.
Hot Air (Convection) Cover
To remove the hot air cover, first remove the left and
right side rack guides, then (See Figure 4-8):
1. Extract screws securing hot air cover to rear wall.
2. Pull hot air cover from rear wall.
Hot Air (Convection) Fan Blade
To remove the hot air fan blade, first remove the left and
right side rack guides and the hot air cover, then (See
Figure 4-9):
1. Extract nut from motor shaft.
NOTE: The shaft and nut are reverse thread.
2. Pull fan blade from motor shaft.
NOTE: The washer and tab washer behind the fan
blade do not need to be removed unless removing
the fan motor assembly which is covered later.
Oven Light Seal
4-7. Light Bulb Removal
4-8. Hot Air Cover Removal
Reverse
Thread
Nut
Washer
4-9. Hot Air Fan Blade Removal
4-5
Component Access
Light Frame
Light Bulb
Light Glass Cover
Hot Air Cover
Tab Washer
Hot Air Fan Blade
#9001333 - Revision A - August, 2014