Wolf CSO24 Service Manual page 16

CSO24 and CSO30 (SWS #13508346)
Checking and Changing Probe Temperature
The TEMP button toggles between displaying the actual probe temperature and the set temperature.
1. To change the set probe temperature, press the TEMP button twice until the display reads "Probe Temperature",
then turn the control knob to set a new temperature and press to select.
End of Cooking
When the set probe temperature is reached, the oven automatically turns off.
• "Probe temperature reached" appears in the text display, and the actual probe temperature appears in the left
digital display.
• The probe symbol will flash and an audible signal will sound for 1 minute.
• Probe temperature may continue to rise due to residual heat.
Preparing for First Use
Cleaning
Clean the cooking space and accessories with warm, soapy water and a soft cloth.
Open the Water Tank
1. Press the WATER button.
Always use this button to open the water tank. Trying to access the water tank manually will damage the oven.
Fill the Water Tank
1. Fill the tank with fresh, cold tap water. Never fill the tank with demineralized, filtered or distilled water.
2. Close the lid.
3. Push the water tank into its compartment and ensure it is seated firmly.
The water tank holds enough water for 1.5 hours of continuous steam, typically enough for four or five cooking ses-
sions. In the event the tank needs refilling in the middle of a cooking session, add no more than 2 cups of water.
This will prevent overflow when water is pumped back into the tank.
Close the Water Tank
1. Close the panel flap manually.
Before Using the First Time
Heat the empty cooking space without baking pans using auto steam bake mode for 30 minutes at 410°F.
Emptying the Water Tank
When the oven is turned off, residual water is pumped back into the water tank.
• "Water is being pumped off" appears in the text display. Residual water is not pumped back until its temperature
is below 175°F (79°C). If "Do not remove water tank" is displayed in the text display, the temperature of the
residual water is still over 175°F (79°C).
• When the water has been pumped back you may remove, empty and dry the water tank.
• When the symbols are no longer illuminated and the text display is dark, the oven is off.
• Any operating mode can be started again at any time
3-7
Theory of Operation
#9001333 - Revision A - August, 2014