Change Engine Oil; Warning Lights And Messages; Red Warning Lights - RAM Commercial Promaster 2018 User Manual

• Up Arrow Button
Push and release the up arrow button to
scroll upward through the main menu and
submenus or adjust the illumination on the
instrument panel when the headlights
are on.
• Down Arrow Button
Push and release the down arrow button to
scroll downward through the main menu
and submenus or adjust the illumination on
the instrument panel when the headlights
are on.

Change Engine Oil

Your vehicle is equipped with an engine oil
change indicator system. The "Change En-
gine Oil" message will display in the instru-
ment cluster display. The engine oil change
indicator system is duty cycle based, which
means the engine oil change interval may
fluctuate, dependent upon your personal
driving style.
Unless reset, this message will continue to
display each time you turn the ignition switch
to the ON/RUN position. To turn off the mes-
sage temporarily, push and release the MODE
button. To reset the oil change indicator sys-
tem (after performing the scheduled mainte-
nance), refer to the following procedure.
1. Turn the ignition switch to the ON position
(do not start the engine).
2. Fully push the accelerator pedal slowly,
three times, within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK
position.
NOTE:
If the indicator message illuminates when
you start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.

WARNING LIGHTS AND MESSAGES

The warning/indicator lights will illuminate in
the instrument panel together with a dedi-
cated message and/or acoustic signal when
applicable. These indications are indicative
and precautionary and as such must not be
considered as exhaustive and/or alternative
to the information contained in the Owner's
Manual, which you are advised to read care-
fully in all cases. Always refer to the informa-
tion in this chapter in the event of a failure
indication. All active telltales will display first
if applicable. The system check menu may
appear different based upon equipment op-
tions and current vehicle status. Some tell-
tales are optional and may not appear.

Red Warning Lights

— Seat Belt Reminder Warning Light
When the ignition is first placed in the ON/
RUN or MAR/ON/RUN position, if the driver's
seat belt is unbuckled, a chime will sound
and the light will turn on. When driving, if the
driver or front passenger seat belt remains
unbuckled, the Seat Belt Reminder Light will
flash or remain on continuously and a chime
will sound. Refer to "Occupant Restraints
Systems" in "Safety" for further information.
— Air Bag Warning Light
This light will turn on for four to eight seconds
as a bulb check when the ignition is placed in
the ON/RUN or MAR/ON/RUN position. If the
light is either not on during startup, stays on,
or turns on while driving, have the system
inspected at an authorized dealer as soon as
31