Clock Setting; Equalizer, Balance And Fade - RAM Commercial Promaster 2018 User Manual

Clock Setting

1. To start the clock setting procedure, push
the SETTINGS button on the right
side of the display, then "Clock" button
on the touchscreen, and then "Set Time &
Format" button on the touchscreen. Se-
lect the up or down arrows as appropriate.
2. Press the up or down arrows to adjust the
hours or minutes, next select the AM or
PM button on the touchscreen. You can
also select 12hr or 24hr format by press-
ing the desired button
touchscreen.
3. Once the time is set, press the "Done" or
"back arrow" button on the touchscreen
to exit the time screen.
NOTE:
Once the time has been set on the radio, the
time will also appear in the instrument clus-
ter display.
134

Equalizer, Balance And Fade

1. Push the SETTINGS
right side of the display.
2. Scroll down and press the "Audio" button
on the touchscreen to open the Audio
menu.
3. The Audio Menu shows the following op-
tions for you to customize your audio
settings.
Equalizer — If Equipped
on the
• Press the "Equalizer" button on the touch-
screen to adjust the Bass, Mid and Treble.
Use the "+" or "-" buttons on the touch-
screen to adjust the equalizer to your de-
sired settings.
Balance/Fade — If Equipped
• Press the "Balance/Fade" button on the
touchscreen to adjust the sound from the
speakers. Use the "arrow" buttons on the
touchscreen to adjust the sound level from
the front and rear or right and left side
button on the
speakers. Press the Center "C" button on
the touchscreen to reset the balance and
fade to the factory setting.
Speed Adjusted Volume — If Equipped
• Press the "Speed Adjusted Volume" button
on the touchscreen to select between OFF,
1, 2 or 3. This decreases the radio volume
relative to a decrease in vehicle speed.
AUX Volume Offset
• Press the "AUX Volume Offset" button on
the touchscreen to activate the AUX Vol-
ume Offset screen.
• The AUX Volume Offset is adjusted by
pressing of the "+" and "–" buttons. This
alters the AUX input audio volume. The
level value, which spans between plus or
minus three, is displayed above the adjust-
ment bar.