Table of Contents
Advertisement
Advanced Hardware
Configuration Settings
Hardware Default Settings
Note
Do not attempt an alternate setting unless you are familiar with its purpose.
In addition, do not reconfigure any switches or jumpers not described in this appendix
unless directed by National Instruments support.
© National Instruments Corporation
This appendix describes the factory-default and alternate hardware
configuration settings of the VXI-1394. The board is set at the factory
for the most commonly used configuration. Use this appendix if you
want to try a different hardware configuration, or if you would like more
information on a particular setting. This information is intended for more
advanced users.
The following hardware configuration settings are user configurable:
•
VXIbus Slot 0/Non-Slot 0
•
Configuration EEPROM
•
VXIbus CLK10 routing
•
Trigger input termination
Figure C-1 shows the factory-default settings of the user-configurable
jumper and switches on the VXI-1394. The slot selection jumper and
six switches are located in the corner of the board behind the front panel
SMB connectors.
C-1
VXI-1394 Interface for Windows NT/98
C
Advertisement
Table of Contents
