Watching TV Programs or Video input
TV / VIDEO
Selecting the TV channels
Select a channel in one of the following two ways.
To scan the memorized channels in numerical sequence
Press CHANNEL s to select the next higher channel.
Press CHANNEL t to select the next lower channel.
Press the button again to select the next memorized channels.
To select a channel directly
Press the Channel Number buttons (0-9 and 100).
To select channel 4, press "4" (or press "0", "4").
To select channel 38, press "3", "8".
To select channel 125, press "100", "2", "5" in sequence.
If you cannot select certain channels, either TV (off the air) or CA-
Check if the TV/CABLE function is properly set. See page 16.
Selecting the video input source
You can use the TV/VIDEO button to view signal coming from other devices,
such as VCR's or video disc players that may be connected to your TV. (See
"Connecting Your TV" on page 5.)
: To operate your TV and video equipment properly, refer to the instructions
furnished with the video equipment.
Turn the TV and the video equipment ON.
Press TV/VIDEO on the Remote Control or
on the TV to select "VIDEO 1" or "VIDEO
The selected source will be displayed in
Operate the video equipment normally.
About the Demonstration Mode
When this function is activated, your TV will automatically display a variety
of its on-screen menus and special features. This function is provided for
demonstration purposes only.
Press MENU, then s or t until "DEMO"
in the Option menu is displayed in purple.
Press T or S to select "START".
The on-screen demonstration will start after
about 15 seconds.
To stop the demonstration
Press EXIT or RECALL on the Remote or select "STOP" in the menu.
VID EO 1
VID EO 2
TO SELECT PUSH TV/VIDEO
C1 C2 C3 C4 T1
T2 T3 T4[OFF]
MOVE[t s] SELECT[T S]