Using the Remote with VCR or Cable TV Converter
To control a TOSHIBA VCR, first set the TV/CABLE/VCR switch to "VCR" position. The buttons shown below
will then control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it.
Details are on page 11.
To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your
converter. See page 11.
The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLE/VCR switch to "CABLE" position whenever you control the cable TV converter.
Press the numbers desired
for direct access.
"CABLE": To control the
To control the VCR
Press to select the TV mode to
view one program while
recording another program.
Press to start recording.
Press to view a slow-motion
picture in playback mode.
Press to freeze the picture during
playback or recording.
Press again to release.
Aim at the VCR or cable TV converter
Press the button to turn the VCR
(or converter) on.
Press again to turn off.
Some VCR's and Cable TV
converters require "ENT" to
change channel number.
CHANNEL s / t
Press s to select next higher channel.
Press t to select next lower channel.
Press to stop the tape.
Press to begin tape playback.
FF (fast forward)
Press to rapidly advance the tape.
In playback mode, press to view the
picture moving rapidly in forward
Press to rewind the tape.
In playback mode, press to view
picture moving rapidly in