Programming The Remote Control; Controlling Other Brands Of Vcr's And Cable Tv Converters - Toshiba 27A50 Owner's Manual

Programming the Remote Control

This Remote Control is preprogrammed to operate TOSHIBA VCR's.
G
To use VCR's other than TOSHIBA models (or cable converter), perform the following procedures before
G
operating.
POWER
RECALL MUTE
o
3
1 2
4 5 6
8 9
7
CH RTN
100 0 ENT
CH
MENU/
VOL VOL
ENTER
CH
TV
CABLE
VCR
EXIT
FAV CH TV/VIDEO
A
REC
TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW
FF
PIP CH LOCATE SWAP

Controlling other brands of VCR's and cable TV converters

1
Refer to the " VCR code table " (or " Cable TV converter code
RECALL
table ") on pages 12 and 13 to find the code number that corresponds to
the brand name of your VCR (or converter).
POWER
If more than one number is listed, try each one separately until you find
the one that works.
Number
2
Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").
3
Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
4
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
–If the right number was entered, the VCR (or the converter) should
turn off.
–If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another code number.
For future reference, write down the code numbers you used:
VCR CODE
CABLE CODE
Notes:
You have to reprogram the Remote Control when you change its batteries.
G
Some newer VCR's are capable of working on either of two remote codes. These VCR's
G
have a switch labeled "VCR1/VCR2".
If your VCR has this kind of switch, and does not respond to all the code numbers for
your VCR brand name, set the switch to another position ("VCR1" or "VCR2") and
reprogram the Remote Control.
11