Programming The Remote Control; Controlling Other Brands Of Vcr's And Cable Tv Converters - Toshiba CE27T11 Owner's Manual

Programming the Remote Control

This Remote Control is preprogrammed to operate TOSHIBA VCR's.
To use VCR's other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
POWER
MTS
TIMER
TV
VCR
CABLE
1 2 3
CH
4 5 6
8 9
7
VOL
CH RTN
100 0
ENT
SUR
ADV
FAV FAV
MENU
- +
ADV
MUTE RECALL TV/VIDEO SURROUND
STOP SOURCE PLAY PIP
REC TV/VCR REW FF
STILL LOCATE SWAP

Controlling other brands of VCR's and cable TV converters

Device
buttons
1
Refer to the " VCR code table " (or " Cable TV converter code
table ") on pages 12 and 13 to find the code number that corresponds to
the brand name of your VCR (or converter).
If more than one number is listed, try each one separately until you find
the one that works.
2
Number
Turn on the device (VCR or converter) you wish to operate with this
buttons
remote.
3
Press the matching Device button "VCR" (or "CABLE") and ENT at the
ENT
same time until the Device button lights up. It indicates that the Remote
Control is in the program mode. Perform the following steps while the
back-light is on (about 20 seconds).
4
Point the Remote Control toward the VCR (or converter) and press the
Number buttons to enter the three digit code number for your brand of
VCR (or converter).
–If the right number was entered, the VCR (or the converter) should
turn off.
–If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another code number until the device
turns off.
The back-light will blink to confirm the storage.
5
Press the Device button again to release the program mode.
VCR CODE
CABLE CODE
Notes:
You have to reprogram the Remote Control when you change its batteries.
Some newer VCR's are capable of working on either of two remote codes. These
VCR's have a switch labeled "VCR1/VCR2".
If your VCR has this kind of switch, and does not respond to all the code numbers
for your VCR brand name, set the switch to another position ("VCR1" or "VCR2")
and reprogram the Remote Control.
11