Mode One: Auto-Charging; Mode Two: Manually Charging - Robot sanbot User Manual

with the adapter and then put the adapter back to its original position. Collect wires extending from the left side of the adapter and put them into card slot. Put the power wire
into the outlet of the right-hand side and put the cover on the adapter compartments.

Mode one: Auto-charging

(1) Plug the power wire of the charging pile into the power socket.
(2) Add the charging pile to the robot (no need to add again hereafter).
① Click "My Device" on the touch screen of the robot.
② If you access this interface for the first time, click "Scan QR code to add a device". If you have added the device, click "Add device".
③ Scan the QR code on the charging pile.
④ Change the device name (such as "charging pile") and click "OK".
⑤ Touch and hold the button on the back of the charging pile until the state of the indicator light of the charging pile blinks, this moment you can release the button.
Attention: If you release the button before or after the state of the indicator light of the charging pile blinks, you will lead to the reset failure.
⑥ Refresh the device list (touch, hold and pull down the device list, or re-access the Intelligent Circle interface, or restart the robot). After several seconds, if the charging
pile displays "Connected", it means finish the connection.
(3) Click the "Settings" on the touch screen of the robot → Battery → Enable auto-recharge → set a minimum residual battery capacity for auto-recharge.
(4) When the robot is being used, its residual capacity is lesser than the setting value or its charging mode is enabled by clicking "Charge", the robot will look for charging piles
to charge itself automatically.

Mode Two: Manually charging

Plug the power wire into the power sock. Move the robot and make the charging metal plates on the back of the robot contact with the charging spring strip. Press the
emergency rechargeable button on the charging pile.
ROBOT USER MANUAL
27