How To Operate - Hitachi CC 14SF Handling Instructions Manual

English
CAUTION
Confi rm that the stopper which was used for installation and removal of the cut-off
wheel has returned to the retract position.

HOW TO OPERATE

1. Procedure for fi xing the cutting material
(Fig. 3 and 4)
Place the workpiece material between vise
(A) and vise (B), raise the clutch and push
the screw handle to bring vise (A) lightly
into contact with the workpiece material, as
shown in Fig. 3.
Then, turn the clutch down, and securely
fi x the workpiece material in position by
turning the screw handle. When the cutting
job is completed, turn the screw handle 2
or 3 times to loosen the vise, and remove
the workpiece material, as shown in Fig. 4.
CAUTION
Never remove or install a workpiece
material while the cut-off wheel is
rotating, to avoid personal injury.
2. Cutting at angles (Fig. 5 and 6)
(1) The machine permits cutting at
angles of 45° or 60°.
(2) Loosen the two M10 hexagon
socket head bolts on the vise (B),
then set the working surface on the
vise-jaw at any angles of 0°, 30°,
or 45° as shown in Fig. 6. Upon
completion of setting, securely
tighten the two M10 hexagon socket
head bolts.
Vise (B)
Vise (A)
Clutch
Screw handle
Vise (B)
Vise (A)
Clutch
Screw handle
90°
60°
When setting at When setting at
an angle of 0° an angle of 30°
Vise (B)
18
Workpiece
material
Fig. 3
Workpiece
material
Fig. 4
45°
When setting at
an angle of 45°
Fig. 5
10 mm bolts
Fig. 6