AtmosAir T400 Replacement Instructions

Congratulations on your purchase of the AtmosAir™ Model T400 air purification system.
AtmosAir™ utilizes state of the art bi-polar ion technology to bring you the finest in air purification.
The T400 is manufactured of industrial grade strength and is suitbale for both residential and light
commercial use. Please find below some simple steps to replace the bi-polar ion tube into the unit
when annual maintenance is required. Your unit is equipped with one (1) tube installed into the unit
and two (2) additional tubes for your annual replacements, so your unit is complete with three (3)
years of required bi-polar ion tubes. Keep this guide handy along with your user's guide to assist you
in replacing your tube when required.
Step 1
After unpacking your T400 unit verify the
following is included:
1. The P2000/P2002 unit
2. The power transformer cord
3. The user's guide
4. Three (3) bi-polar ion tubes. One has
already been installed in your unit so
it can be used immediately and the
other two (2) tubes to be stored for
future replacement needs.
WARNING: BEORE PROCEEDING WITH TUBE REPLACEMENT PLEASE BE
Step 2
Remove the T400 top section from the
unit by removing the two (2) screws that
fasten the top section. Use a common
phillips head screwdriver for this.
AtmosAir™ Model T400
Ionization Tube Replacement Instructions
SURE ALL POWER IS DISCONNECTED FROM THE UNIT