Advertisement
Cables should always be handled with great care. When
running the cables, avoid bending them too sharply
and be careful not to twist them. Avoid subjecting the
cables to pressure or impact.
Using the cable supplied, connect the BeoLink Active
receiver as follows:
1 Detach the rear cover of the BeoLink Active receiver
(unscrew the two screws (C) and loosen the two screws
(D), then lift off the cover).
2 Cut the cable to the required length (from the BeoLink
Active box to the receiver) and strip it as shown.
3 Insert the cable end through the cable clamp (E) and
connect the leads to the terminals inside the receiver
in the order indicated. Then tighten the clamp (E).
4 Attach the rear cover again and fasten the BeoLink
Active receiver to the wall (see page 4).
5 Plug the cable into the socket marked IR on the BeoLink
Active box.
NOTE! Disconnect your entire
Bang & Olufsen system from the
mains while you make the
connections!
C O N N E C T I O N S
Connect the leads in the receiver
cable to the terminals inside the
receiver in this order:
1 = Yellow
2 = Grey
3 = Green
4 = White
5 = Brown
Strip the cable end. Twist the
cores in each lead and bend
them back.
5
1
2
3
4
5
E
>
Advertisement
