Siemens SIMATIC HMI TP 170A Equipment Manual page 81

Number
190010 The tag is described with values too often
(e.g. in a loop triggered by a script).
Values are lost because the maximum of 100
event have been stored in the buffer.
190011 There are two causes for this message:
The value entered could not be written to
the configured PLC tag because it was
either above or below the value range.
The input is rejected and the original
value is reset.
Connection to the PLC has been
interrupted.
190012 It is not possible to convert a value from a
source format to a target format, e.g.:
A value should be assigned to a counter
which is outside the valid,
PLC-dependent value range.
A tag of the type Integer should be
assigned a value of the type String .
190100 The area pointer is not updated because the
configured address for this area pointer is not
available.
Type:
1 Event messages
2 Alarm messages
3 PLC acknowledgment
4 Operating unit acknowledgment
5 LED assignment
6 Trend request
7 Trend transfer 1
8 Trend transfer 2
No.
is the consecutive number displayed in
ProTool/Pro.
190101 The area pointer is not updated because it is
not possible to map the PLC type in the area
pointer type.
Parameter type and no.:
See message 190100
190102 The area pointer is updated following an
error status after the cause of the last error
state has been eliminated (return to normal
operation).
Parameter type and no.:
See message 190100
200000 Coordination is not executed because the
address configured in the PLC does not
exist/has not been set up.
200001 Coordination is not executed because the
address configured in the PLC cannot be
written.
TP 170A Equipment Manual
Release 12/99
CuuDuongThanCong.com
Effect/Cause
System Messages
Remedy
Increase the time interval between the
multi-writing tasks.
Ensure that the value entered is within the
value range of the PLC tags.
Check the connection to the PLC.
Check the value range or type of the
variable.
Check the configuration.
–
–
Change the address or set up the address in
the PLC.
Change the address or set up the address in
the PLC in an area which can be written.
https://fb.com/tailieudientucntt
C-11