Rear Panel; Specifications - Fender MB-1200 Owner's Manual

D . PARALLEL SPEAKER OUTPUTS - Use any
combination of these outputs to con-
nect speaker cabinets. Each Speakon ®
connector can accommodate two
speakers using a 4–pole
"Y-cable. "
The recommended speaker configu-
rations below provide the optimal
2–ohm total impedance load:
(one 2Ω cabinet)
(two 4Ω cabinets)
(one 4Ω and two 8Ω cabinets)
(four 8Ω cabinets)
E . IEC POWER CORD SOCKET - Connect
only the supplied special high-capacity power cord to a
grounded AC receptacle in compliance with the voltage
and frequency ratings specified on the rear panel of your
MB-1200.
F . BALANCED (1/4") LINE INPUT - Plug your preamp output
into this jack when using an instrument cable with mono
(TS) or stereo
Sleeve=Ground. This jack will disable the XLR jack-{G}.
TYPE:
PART NUMBERS:
2147500000 (120V, 60Hz) US, 2147503000 (240V, 50Hz) AUS, 2147504000 (230V, 50Hz) UK,
2147506000 (230V, 50Hz) EUR, 2147507000 (100V, 50Hz) JPN
POWER REQUIREMENT: 1800W
POWER OUTPUT: 1200W RMS into 2Ω @ 1%THD
INPUT IMPEDANCE: 18kΩ balanced
INPUT SENSITIVITY:
POWER AMP PASS THRU: OUTPUT IMPEDANCE: 220Ω,
POWER CORDS: 0069133000 (120V, 60Hz) US, 0047250000 (240V, 50Hz) AUS, 0047249000 (230V, 50Hz) UK,
0047251000 (230V, 50Hz) EUR, 0069142000 (100V, 50Hz) JPN
RECOMMENDED SPEAKERS:
DIMENSIONS: HEIGHT: 3.5 in (8.9 cm),
WEIGHT:
(TRS) plugs; Tip=(+), Ring=(–),

Specifications

PR 535
1V RMS (0dBV)
810 Pro (2217200000),
35 lb (15.9 kg)
Product specifications are subject to change without notice.

Rear Panel

G . BALANCED (XLR) LINE INPUT - Plug your preamp output
into this jack when using a microphone cable with standard
XLR connectors. Use of a balanced microphone or
1/4" TRS cable will normally provide a better Signal-to-
Noise ratio (hum-free, cleaner sound).
H . POWER AMP PASS THRU OUTPUTS - When using one
preamp to drive multiple power amps, use these jacks
to connect to the inputs of additional power amps. The
signal at each of these jacks is an exact, buffered replica of
the signal connected at the input {F} or {G}. (Again, while a
typical mono TS guitar cable is adequate, using a balanced
TRS cable will ensure hum-free operation.)
NOMINAL LEVEL: 0dBV
410 Pro ST/SL (2217100000 / 2217000000),
WIDTH: 19.0 in (48.3 cm),
Bassman ® 212 (2217300000),
DEPTH: 15.0 in (38.1 cm)
7