Table of Contents
Advertisement
MAINTENANCE & CLEANING
CAUTION: Before servicing or cleaning unit, completely disconnect the
unit from the power source.
1.
Hot water with liquid soap can remove most stains easily.
2.
Always rinse the surface with clean water and wipe dry with a soft clean
cloth to prevent water marks.
3.
Hard to remove stains, discolourations, and persistent deposits can be
removed with a non-abrasive household cleaner or stainless steel polishing
powder with a little water.
4.
For stubborn stains and deposits, use a scouring pad or soft bristle
brush along with a stainless steel cleaner and water. Always rub in the
direction of the polished lines, or "grain" of the stainless steel nish.
Avoid using too much pressure as it may mar the surface.
5.
Do not allow deposits to remain for long periods of time. Do not use
ordinary steel wool or steel brushes to clean the range hood.
6.
Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds
to remain in contact with the stainless steel surface for prolonged periods
of time. Many of these compounds contain chemicals that can be harmful
to the stainless steel nish. Always rinse with water after every cleaning
and wipe dry with a clean cloth.
Baf e Filter
WARNING: If the range hood and lters are not cleaned periodically,
it may become a re hazard
1.
The baf e lter should be cleaned frequently; minimum every two months
2.
The baf e lters are made of surgical grade T304 stainless steel, and are
dishwasher safe
a.
Use only mild soap or detergent solutions
b.
DO NOT allow salt solutions, disinfectants, bleaches, cleaning
compounds, or rubbing compounds to remain in contact with
stainless steel for extended periods of time. Many of these
compounds contain chemicals which may be harmful to the
surface of the range hood. Rinse with water after exposure and
wipe dry with a clean lint-free cloth
c.
DO NOT allow deposits to accumulate or remain on the hood
d.
DO NOT use ordinary steel wool or steel brushes. Small bits of
steel may adhere to the surface
7.
Remove the lter by pushing it towards the front of the hood, then pivot
the lter loose from the back
8.
Allow the lter to dry completely before reinserting
8
Advertisement
Table of Contents
