Inserting Strap Into Tool - Signode 4A1-114 Operation, Parts And Safety Manual

INSERTING STRAP INTO THE TOOL
1. Rotate the tensioning handle all the way down to lock the gripper in the open position.
Adjust the windlass so that the slot is in line with angle of strap.
TYPICAL ORIENTATION FOR TOP LOADS
2. Insert lower/inner strap in opening between gripper and base of tensioner until the strap is
fully in contact with the inner wall of the base (strap guide). Make sure that the lower/inner
strap is inserted over the base foot. Insert top/outer strap fully into windlass slot.
Approximately 2 to 4 inches should extend beyond windlass; cut off any excessive length
before tensioning.
TYPICAL ORIENTATION FOR TOP LOADS
TYPICAL ORIENTATION FOR SIDE LOADS
TYPICAL ORIENTATION
FOR SIDE LOADS
7