Signode 4A1-114 Operation, Parts And Safety Manual page 15

h. Push the gripper shaft fully into the base.
i. Remove the screwdriver and install the roll pin (26) into the hole in the gripper release
cam.
j. Install the gripper (20) and gripper spring (22).
NOTE: After the tool is reassembled, crank the tension handle several times to be sure that
set screws (3) are not binding the handle pawl or base pawl. If either pawl is binding, turn the
appropriate set screw counterclockwise 1/2 turn at a time and recheck each time by cranking
the handle.
15