General Safety Instructions - Signode 4A1-114 Operation, Parts And Safety Manual

READ THESE INSTRUCTIONS CAREFULLY. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN
RESULT IN SEVERE PERSONAL INJURY.
GENERAL SAFETY CONSIDERATIONS
1. TOOL MANUAL
Before using this tool read and understand the operation manual.
2. STRAP BREAKAGE HAZARD
Never position yourself in-line with the strap during tensioning and sealing. Properly position
yourself when tensioning and sealing as shown in the operating instructions.
Improper operation of the tool, sharp corners on the load, improper strap placement around
the load or an unstable or shifted load could result in strap release or breakage, during
tensioning. This could result in the following:
! !
A sudden loss of balance causing you to fall.
! !
Both tool and strap flying violently towards your face.
3. TRAINING
This tool must not be used by persons not properly trained in its use. Be certain that you
receive proper training from your employer. If you have any questions contact your Signode
Representative.
4. EYE INJURY HAZARD
Failure to wear safety glasses with side shields can result in severe eye injury or
blindness. Always wear safety glasses with side shields which conform to ANSI
Standard Z87.1 or EN 166.
5. FALL HAZARD
Maintaining improper footing and/or balance when operating the tool can cause you to fall.
Do not use the tool when you are in an awkward position.
6. CUT HAZARD
Handling strap or sharp parts could result in cut hands or fingers. Wear
protective gloves.
7. TOOL CARE
Take good care of the tool. Inspect and clean it daily, lubricate it weekly and adjust when
necessary. Replace any worn or broken parts.
8. WORK AREA
Keep work areas uncluttered and well lighted.
2