Operating Instructions Overview - Signode 4A1-114 Operation, Parts And Safety Manual

OPERATING INSTRUCTIONS
When tensioning or sealing, position yourself according to the operation instructions for
the type of load being strapped. Keep all bystanders away.
It is recommended that safety belts be worn by operators working on at elevated positions.
Never increase the length of the tensioning handle by any means such as extending the
handle length.
Apply tensions that are proper for the size and type of strap being used and is compatible
with the loads being strapped and its corner characteristics. Contact your Signode Sales
Representative if you have any questions.
Tuck the strap end back into the dispenser when you are not using it.
Operating instructions are broken down into the following sequences:
1. Placing strapping around a load.
2. Inserting strapping into tool.
3. Tensioning strap when on top of a load.
4. Tensioning vertical strap for sides of a load.
5. Tensioning strap for wall anchored load and horizontal strap.
The warning label shown below (177896) is installed on every tool handle. If this label becomes
damaged, replace it immediately. Ensure that a plastic shrink tube sleeve us applied over the
label. Contact your Signode Sales Representative if you have any questions.
5