Toshiba R410A Service Manual page 35

Operation section
Push each button to select a desired operation.
• The details of the operation needs to be set up once, the same states are used by pushing
button.
2
3
4
5
1
Fan mode button
Selects a fan mode.
2
Timer set button
TIMER SET button is used when the timer is
set up.
3
Check button
CHECK button is used for check operation.
During normal operation, do not use this
button.
4
Fan button
FAN button is used when a fan which is sold on
the market or etc. is connected.
• If "No function" is displayed on the remote
controller when pushing the FAN button, a
fan is not connected.
5
Filter reset button
Resets (Erases) "FILTER
6
UNIT and AUTO flap button
No function
7
Operation lamp
Lamp is lit during the operation. Lamp is off
when stopped.
It flashes when operating a protection device
or abnormal occurred.
1
7
UNIT
SET CL
6
8
9
10
FILTER UP/DOWN button
" display.
OPTION :
Remote controller sensor
Usually the TEMP . sensor of the indoor unit mea-
sures a temperature. A temperature around the
remote controller can also be measured.
For details, contact the dealer from which you have
purchased the air conditioner.
35
button
When the button is pushed, operation starts,
and it stops by pushing the button again.
When the operation stops, the operation lamp
and all displays disappear.
Operation select button
Selects operation mode.
Set up temperature button
Adjusts required room temperature.
Set required set temperature by pushing
or .
(No function display)
8
9
10