Toshiba CARRIER RAV-SP180CT-UL Installation Manual page 9

Under Ceiling Type
Upper pipe draw-out port (knockout)
Hole for remote control wires (knockout)
(Hole for power supply cable. knockout)
3.3" (84)
Left drain size
Refrigerant pipe (Gas side ØD)
Hanging bolt
Ceiling surface
Unit
Considering pipe/wire connecting work inside the ceiling after the indoor unit has been hanged, select an
installation place and determine piping direction.
• If the ceiling has already been set before hanging the main unit, prepare refrigerant pipe, drain pipe, indoor
connecting wire, remote control cord, etc. up to the place where pipe and wire can be connected.
• Check the size of the indoor unit, and match the indoor unit size using the attached installation pattern.
Conduit hole
Refrigerant pipe
(Liquid side ØC)
B (Hanging position)
3.0" (75)
5.3" (135)
Pipe hole on wall
(Ø3.9" (100) hole)
Outside air take-in port (Duct sold separately)
Knockout hole Ø3.6" (92))
A
1.5" (39)
2.0" (52)
8.5" (216)
8.3" (210)
4.3" (110)
3.0" (76)
4.1" (105)
Drain pipe
connecting
port
3.8" (97)
5.7" (146)
Hole for remote control wires
13.7" (347)
Conduit hole
12.2" (311)
(knockout)
10.3" (262)
Hole for power supply cable
Wireless sensor
mounting section
Model name
180CT
240CT
(1180)
300CT, 360CT
to 420CT (1595)
– 8 –
Installation Manual
Unit: in (mm)
6.6" (167)
Pipe draw-out port
(knockout)
Drain port VP20
(Inner dia. Ø1.0" (26), hose
attached)
3.3" (84)
Left drain pipe
draw-out port
(knockout)
Unit: in (mm)
A B C
35.8" 33.7" Ø1/4"
(910) (855) (6.4)
46.5" 44.3"
(1125)
Ø3/8"
(9.5)
62.8" 60.6"
(1540)
D
Ø1/2"
(12.7)
Ø5/8"
(15.9)
EN
8-EN