Toshiba CARRIER RAV-SP180CT-UL Installation Manual page 25

Under Ceiling Type
3
-2,
4
-2,
5
-2
7
1
1
Procedure
Push simultaneously +
seconds or more. After a while, the display part flashes
as shown below. Check the displayed CODE No. is
[10].
• When the CODE No. is other than [10], push
button to erase the display and repeat procedure
from the first step.
(After pushing button, operation of the remote
control is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
(* Display changes according to
the model No. of indoor unit.)
2
Procedure
Every pushing button, the indoor UNIT No. in
the group control is displayed in order. Select the
indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan and
louver of the selected indoor unit operate.
3
Procedure
1. Using temp. setup
No. [12].
(CODE No. [12]: Line address)
2. Using timer time /
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
7
3
-1,
4
-1,
5
-1,
3
-3,
4
-3,
5
-3,
2,6
+ buttons for 4
/ buttons, specify CODE
buttons, change the line
Indoor UNIT No. before setup change is displayed.
4
Procedure
1. Using temp. setup
No. [13].
(CODE No. [13]: Indoor address)
2. Using timer time
address from [3] to [2].
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor UNIT No. before setup change is displayed.
5
Procedure
1. Using temp. setup
No. [14].
(CODE No. [14]: Group address)
2. Using timer time
data from [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit:
0002])
3. Push button.
In this time, the setup finishes when the display
changes from flashing to lighting.
Indoor UNIT No. before setup change is displayed.
– 24 –
Installation Manual
/ buttons, specify CODE
/ buttons, change the indoor
/ buttons, specify CODE
/ buttons, change the setup
EN
24-EN