Advertisement
TOSHIBA INTERNATIONAL CORPORATION
Industrial Division / Houston Motor Plant
3.
STANDARD SERVICE (-cont.)
5.
6.
7.
Fig. 2
Standard Duty
Severe Duty
Very Severe Duty
4.
RECOMMENDED GREASES:
Confirm if the motor nameplate has specified the grease used.
Standard, Severe Duty and 841 motors greased at the factory will use:
5.
RECOMMENDED GREASES for STANDARD APPLICATIONS
Use the following greases listed for the given temperature range, unless otherwise shown by the motors
grease nameplate:
Chevron SRI
Exxon Unirex #2
Exxon Polyrex
Shell Dolium R
Polystar RB 2
TOSHIBA INTERNATIONAL CORPORATION
Motor Operation Procedure
Remove relief plug or plate and using a low pressure hand held grease gun, pump the required
amount of grease.
For Frames 143T to 365T allow motor to run for 20 to 30 minutes and for Frames 405T and
larger allow motor to run for 30 to 60 minutes before replacing hardware.
Grease may not relieve from drain. Use volumes recommended to avoid overgreasing.
SERVICE CONDITIONS
Eight hours per day;
Light to normal loading;
Clean condition, free from dust.
24 hours per day;
Light to normal shock loading, vibration;
Exposure to dirt or dusty conditions.
24 hours per day;
High ambient;
Normal to high shock loading, vibration;
Dusty conditions;
Confined mounting conditions
Grease Name:
Manufactured By:
Operating Ambient Temp.:
Operating Ambient Temp. -30°C to 50°C
Chevron SRI
Chevron U.S.A., Inc.
-30°C to 50°C
Chevron U.S.A., Inc.
Exxon Corp.
Exxon Corp.
Shell Oil Co.
Texaco
INDEX
MDS-O-0001
SHEET NO.
2 of 3
ISSUED
01/24/96
SUPERSEDES
NEW
INDEX
MDS-O-0001
Advertisement
