Function Change; Pretrip Check - Carrier Transicold Vector Manual

Function Change

HEAT COOL DEFROST ALARM
SETPOINT
PRESS TO VIEW SETTINGS
=
MANUAL
DEFROST
1
1
Press the SELECT key until FUNCTION
CHANGE is highlighted. The message
"PRESS
2
2 Press the UP or DOWN ARROW to scroll through
the Function list. "TO SCROLL THEN = TO
SELECT" will appear.
3 To change one of the Functions, bring the Function
3
you wish to change into the Message Center, and
press = (ENTER) key. "TO SCROLL, THEN = TO SAVE"
will show in the Message Center. Pressing either UP or
DOWN ARROW key will begin to change the Function
setting. The Message Center will flash, indicating that a
change has been made that has not been entered into
memory.
4
4
Continue pressing UP or DOWN ARROW key until the
desired value is shown, then press the = (ENTER) key.
The Message Center will stop flashing. The new value is
now in memory.
CONTINUOUS
START-STOP RUN
LANGUAGE
STANDBY
BOX TEMPERATURE
ENGINE
FUNCTION 1
START/RUN
CHANGE
ALARM LIST SELECT
START-STOP
!
CONTINUOUS
0 STOP
TO VIEW SETTINGS" will appear.

Pretrip Check

HEAT COOL DEFROST ALARM
SETPOINT
TEST # 1
=
MANUAL
DEFROST
1
1 Press the SELECT key until PRETRIP
is illuminated.
2
2 Press the = key to start PRETRIP.
3 Verify that the display shows "TEST # 1".
3
Note : Unit can be off when you start PRETRIP
Press and hold the = key for 5 seconds
will cancel the PRETRIP.
CONTINUOUS
START-STOP RUN
LANGUAGE
STANDBY
BOX TEMPERATURE
ENGINE
1
START/RUN
DATA
ALARM LIST SELECT
START-STOP
!
CONTINUOUS
0 STOP