Sea gull lighting HC-905 Installation And Safety Instructions

INSTALLATION AND SAFETY INSTRUCTIONS
FOR YOUR SAFETY
WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU
ARE WORKING ON IS SHUT OFF. EITHER THE FUSE REMOVED
OR THE CIRCUIT BREAKER OFF .
GENERAL
You don't need special tools to install this fixture. Be sure to follow the
steps in the order given. Read instructions carefully. If you are unclear
as to how to proceed, consult a qualified electrician.
NOTE: Proper wiring is essential for the safe operation of this
fixture.
ASSEMBLY
Carefully remove the fixture from the carton and check that all
parts are included, as shown in Figure 1 & 2. Be careful not to
misplace any of the screws or parts which are needed to install
this fixture.
STEP 1:
Attach finial [A] to top assembly [B] of fixture (if not factory installed).
CAUTION:
Fixtures with photo-cells should be mounted at least 48"
from all sides to avoid reflection of light back onto Photo-cell,
causing the Photo-cell to malfunction or flicker.
NOTE: To keep your solid polished brass fixture look-
(FIG. 1)
quality non-abrasive car wax to all metal surfaces, giv-
FINIAL (A)
TOP
ASSEMBLY (B)
NOTE: This glass is handcrafted, the slight imperfections in
SCREWS (C)
CAGE (D)
FITTER (E)
File This Sheet For Future Reference.
ing new for years to come, regularly apply a good
ing the fixture an extra protective coating.
WARNING
NOTE: DO NOT INSTALL ON A POST OR A POLE THAT
RESULTS IN A VERTICAL RISE OF 25 FEET OR HIGHER.
the glass add to the authenticity of the fixture.
NOTE: Be sure that all sections of top finial are
securely tightened to prevent water seepage into
the fixture
Installation And
Safety Instructions
HC-905
Line art shown may not exactly match the fixture
enclosed. However, the installation instructions
do apply to this fixture.
061605
ITEM#_______________