Sea gull lighting HC-1506 Installation And Safety Instructions

Installation And Safety Instructions
Line art shown may not exactly match the fixture enclosed. However, the installation instructions do apply to
this fixture. Fill in Item Number on Carton and File This Sheet For Future Reference. ITEM#_______________
IMPORTANT SAFETY INSTRUCTIONS
• Be sure the electricity to the system you are working on is turned
off; either the fuse removed or the circuit breaker set at off.
• Use of other manufacturers components will void warranty, listing
and create a potential safety hazard.
• If you are unclear as to how to proceed, contact a qualified electrician.
• You don't need special tools to install this fixture.
• Be sure to follow the steps in the order given.
• Read instructions carefully.
• Save these instructions.
NOTE: This glass is handcrafted, the slight imperfections in the
glass add to the authenticity of the fixture.
NOTE FOR FIXTURES THAT ARE SOLID BRASS:
NOTE: TO KEEP YOUR SOLID POLISHED BRASS FIXTURE LOOKING
NEW FOR YEARS TO COME, REGULARLY APPLY A GOOD QUALITY
NON-ABRASIVE CAR WAX TO ALL METAL SURFACES, GIVING THE
FIXTURE AN EXTRA PROTECTIVE COATING.
BEFORE YOU BEGIN
Carefully remove the fixture from the carton and check that all parts
are included, as shown in figure 1. Be careful not to misplace any of
the screws or parts which are needed to install this fixture.
*OUTLET BOX
FIGURE 1
UNIVERSAL GREEN
MOUNTING GROUNDING
BAR (A) SCREW (H)
*WIRE *OUTLET BOX
CONNECTORS SCREWS
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order
replacement parts. Parts for this fixture can be ordered from place of
purchase. Be sure to use exact wording from illustration when
ordering parts.
WET LOCATION
NOTE: FOR FIXTURES LABELED FOR WET LOCATION AND
USED OUTDOORS.
CAUTION: To reduce the risk of electrical shock, provide a
watertight seal between the fixture and the mounting surface by
using a silicone or similar caulking.
MOUNTING
SCREWS (B)
BACK
PLATE (C)
HC-1506
112508
GLASS (E)
RETAINING
RING (G)
*NOT INCLUDED