Safety And Instructional Decals - Toro 20066 Operator's Manual

•
Extinguish all cigarettes, cigars, pipes, and other sources
of ignition.
•
Use only an approved gasoline container.
•
Never remove gas cap or add fuel with the engine
running. Allow engine to cool before refueling.
•
Never refuel the machine indoors.
•
Never store the machine or fuel container where there
is an open flame, spark, or pilot light such as on a water
heater or on other appliances.
•
Never fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers
on the ground away from your vehicle before filling.
•
Remove gas-powered equipment from the truck or
trailer and refuel it on the ground. If this is not possible,
then refuel such equipment with a portable container,
rather than from a gasoline dispenser nozzle.
•
Keep the nozzle in contact with the rim of the fuel
tank or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
•
If fuel is spilled on clothing, change clothing
immediately.
•
Never overfill fuel tank. Replace gas cap and tighten
securely.
Exhaust contains carbon monoxide, an odorless,
deadly poison that can kill you.
Do not run the engine indoors or in an enclosed area.
General Service
•
Never operate machine in a closed area.
•
Keep all nuts and bolts tight to be sure the equipment is
in safe working condition.
•
Never tamper with safety devices. Check their proper
operation regularly.
•
Keep machine free of grass, leaves, or other debris
build-up. Clean up oil or fuel spillage and remove
any fuel-soaked debris. Allow machine to cool before
storing.
•
If you strike a foreign object, stop and inspect the
machine. Repair, if necessary, before starting.
•
Never make any adjustments or repairs with the engine
running. Disconnect the spark plug wire and ground
against engine to prevent unintended starting.
•
Check grass catcher components and the discharge
guard frequently and replace with manufacturer's
recommended parts, when necessary.
•
Mower blades are sharp. Wrap the blade or wear gloves,
and use extra caution when servicing them.
•
Do not change the engine governor setting or overspeed
the engine.
•
Maintain or replace safety and instruction labels, as
necessary.

Safety and Instructional Decals

Important: Safety and instruction decals are located
near areas of potential danger. Replace damaged
decals.
Manufacturer's Mark
1. Indicates the blade is identied as a part from the original machine
manufacturer.
Model 20067 only
3
94-8072
104-7402