Cleaning The Mower; Preparing The Mower For Storage - Toro 20066 Operator's Manual

Cleaning the Mower

The mower may dislodge material from under the
mower housing.
•
Wear eye protection.
•
Stay in the operating position (behind the
handle) when the engine is running.
•
Do not allow bystanders in the area.
For best results, clean the mower soon after you have
completed mowing.
1. Lower the mower to its lowest cutting height setting.
Refer to Adjusting the Cutting Height.
2. Move the mower onto a flat paved surface.
3. Attach a garden hose that is connected to a water supply
to the washout port on the mower housing (Figure 36).
Figure 36
4. Turn the water on.
5. Start the engine and run it until there are no more
clippings that come out from under the mower housing.
6. Stop the engine.
7. Shut off the water and disconnect the garden hose from
the mower.
8. Start the engine and run it for a few minutes to dry the
housing to prevent it from rusting.
Storage
Store the mower in a cool, clean, dry place.
Preparing the Mower for
Storage
Gasoline vapors can explode.
•
Do not store gasoline more than 30 days.
•
Do not store the mower in an enclosure near an
open flame.
•
Allow the engine to cool before storing it.
1. On the last refueling of the year, add fuel stabilizer to
the fuel as directed by the engine manufacturer.
2. Dispose of any unused fuel properly. Recycle it
according to local codes, or use it in your automobile.
Note: Old fuel in the fuel tank is the leading cause of
hard starting. Do not store fuel without stabilizer more
than 30 days, and do not store stabilized fuel more than
90 days.
3. Run the mower until the engine stops from running
out of fuel.
4. Prime the engine and start it again.
5. Allow the engine to run until it stops. When you can no
longer start the engine, it is sufficiently dry.
6. Disconnect the wire from the spark plug and connect
the wire onto the retaining post.
7. Remove the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole, and pull the starter rope slowly
several times to distribute oil throughout the cylinder to
prevent cylinder corrosion during the off-season.
8. Loosely install the spark plug.
9. Tighten all nuts, bolts, and screws.
10. Charge the battery for 24 hours, then unplug the battery
charger an store the mower in an unheated area. If you
must store the mower in a heated area, you must charge
the battery every 90 days (model 20067 only).
18