Operating Tips; Cutting Grass - Toro 20066 Operator's Manual

Figure 22
Removing the Side Discharge Chute
To remove the side discharge chute, reverse the steps above.
Important: Lock the side discharge door after you
close it (Figure 23).
Figure 23

Operating Tips

General Mowing Tips
•
Clear the area of sticks, stones, wire, branches, and
other debris that the blade could hit.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the mower strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the mower for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.

Cutting Grass

•
Cut only about a third of the grass blade at a time. Do
not cut below the 2-inch (51 mm) setting unless the
grass is sparse or it is late fall when grass growth begins
to slow down. Refer to Adjusting the Cutting Height.
•
When cutting grass over 6 inches (15 cm) tall, mow
at the highest cutting height setting and walk slower;
then mow again at a lower setting for the best lawn
appearance. If the grass is too long, the mower may
plug and cause the engine to stall.
•
Mow only dry grass or leaves. Wet grass and leaves tend
to clump on the yard and can cause the mower to plug
or the engine to stall.
Wet grass or leaves can cause serious injury if
you slip and contact the blade. Mow only in dry
conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep the
mower free of dry grass and leaf debris.
13