Unfolding The Handle; Filling The Engine With Oil; Installing The Fuse - Toro 20066 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.

1. Unfolding the Handle

Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when folding or
unfolding the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Carefully move the upper handle forward until the
handle halves are in line and nest together as shown
(Figure 3).
Figure 3
2. Tighten the handle knobs (Figure 4).
Figure 4
3. Rotate the handle rearward (as shown) until it clicks
into place (Figure 5).
Figure 5

2. Filling the Engine with Oil

Your mower does not come with oil in the engine, but it
does come with a bottle of oil.
1. Remove the dipstick (Figure 6).
Figure 6
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 6). Do not
overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil.

3. Installing the Fuse

Model 20067 only
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you install
the fuse.
1. Unclip both ends of the battery cover and remove it
(Figure 7).
6